How to Calculate the values and write in the file

graswant

Hi
I have a JCL which gives me following output..

expat · Posted: Wed May 21, 2008 4:39 pm Post subject:

What have you tried so far, and what problems are you getting ?

graswant · Posted: Wed May 21, 2008 4:45 pm Post subject: Hi

Well my friend..U can say...I am 0 in REXX..and haven't tried anything coz I don't know REXX.... The calculation cannot be done in JCL so I don't have another option ...other than using REXX......

expat · Posted: Wed May 21, 2008 4:58 pm Post subject:

I am more than willing to HELP people with code problems, but certainly not to supply custom code for them, unless paid to do so.

My current rate would be around 500 euro for the task above

This is an excellent opportunity for you to sit down with the REXX manual and try a few things out, and to start learning the language. Then is the time to post on the forum for help rather than code.

Good luck.

graswant · Posted: Wed May 21, 2008 6:24 pm Post subject: Hi

Hahahhahaha....Well said my friend...but If I would have time to read then I would have done that myself first.....but I need to finish this in a day or so....else I am dead....with a dead army of soldiers.... hehehehe.....Please give me some sample code.....

cpuhawg

Doing calculations in REXX are as easy as writing an equation.

graswant · Posted: Wed May 21, 2008 7:04 pm Post subject: Hi

Thanks Cpuhawg.... If I would know the code ...I would be able to do the multiplication and division....but unluckily...I don't know how to write the code in Rexx..... Expat wants 500 Euros.... hahahahaha for this task...well I am still waiting for someone or him to help me with the code....or give me a sample code to solve my problem.......may be he might give the code free to me..... hahahahaahahaha........

Pedro

1. Your existing JCL needs to be changed to put the report into a file that can be accessed later.

2. You need an additional step that has a DD with a referback to previous report.

3. that new step is PGM=IKJEFT01 and calls your new rexx routine

4. rexx routine needs to read the report and process 1 record at a time, doing the required math.

Please send 495 Euros to me for consultation.

enrico-sorichetti

why write code when ISMF volume application provides You with all You need???

dick scherrer · Posted: Thu May 22, 2008 8:02 am Post subject:

Hello,

Not knowing rexx should not prevent getting an answer.

If you are a programmer, you can use any language (cobol, easytrieve, etc), to read the data you posted and do the calculation.

If you need this in a hurry, you have alternatives.

expat · Posted: Thu May 22, 2008 11:39 am Post subject:

enrico-sorichetti

graswant

Well ...I appologise...but I was laughing on the money asking things...not on the time and importance of the thing...It is important for me to get this done....well if someone can give me some advise....Most welcome...if someone can't then also thanks....

graswant · Posted: Thu May 22, 2008 7:47 pm Post subject: Hi

Thanks to all of you ....friends...I did it myself....after a lot of reading till the time I was not getting replies...I finally did it...and it works fine...will all the details I need....few last min touching needed which I will do....but thanks again for the great Forum we have.....

Pedro