Problem in EDIT MACRO

Balaji.helios · New User Joined: 12 Jun 2007 Posts: 8 Location: chennai

I'm checking 10 members in a PDS. In each member I'm issuing a CHANGE command and I write some information to output file. After then when I issue an END command in my MACRO it's not coming out !!!

For each and every member I need to press F3, to do check for the next member and so on, until all the members in the PDS are checked. Is there any way to execute without pressing F3.

Pedro · Posted: Tue Jul 22, 2008 6:11 am Post subject: Reply to: Problem in EDIT MACRO

Can you show your macro? (if it is longer than a dozen or so lines, please abbreviate the macro). END should cause to leave editor.

Balaji.helios · New User Joined: 12 Jun 2007 Posts: 8 Location: chennai

Hi...please see my simple macro

i tried it with simple change command.

I DONT WANT TO SAVE THE CHANGES

ADDRESS ISREDIT
'ISREDIT MACRO'
'ISREDIT CHANGE ALL "&" ""'
'ISREDIT 'END'

Thank you in advance

dbzTHEdinosauer · Posted: Tue Jul 22, 2008 11:58 am Post subject:

an END with out automatic save, requires that you perform 2 ENDs.

try using CANCEL, since you do not want to save the changes.

ofer71 · Posted: Tue Jul 22, 2008 12:15 pm Post subject:

Or use "SAVE" followed by "END" if you do want to save the changes.

By the way, you can always test the RC of the END command and get a clearer information regarding why the command has failed.

O.

Balaji.helios · New User Joined: 12 Jun 2007 Posts: 8 Location: chennai

Thanks everybody..

I tried ISREDIT CANCEL command,And it worked perfect.Thanks a lot